This controller offers excellent temperature stability of ±0,05K. The Peltier output is pulse width modulated 10 kHz, for fan 2 are independently from each other programmable outputs. As a sensor is used a NTC resistor, this is included.

• Input Voltage 10 ... 30 VDC (no built-in power supply!)
• Maximum output current 15 A (up to 30 A with additional cooling)
• PWM clocked at 10 kHz getaktet, no lifetime limitation for Peltier Modules
• Control range: -20°C ... +100°C with standard-NTC, other areas possible, depending on sensor
• Resolution ±0,05K, Stability ±0,05K
• Cooling and heating
• Temperatur sensor: NTC, other sensors possible
• Remote control via RS232 interface
• Free programmable

Delivery:
1 pc programmable controller PR-59
1 pc temperatur sensor TC-NTC-1
1 pc wire TC-WIRE3-PR59
1 sheet A4 Quick Guide
1 sheet A4 connection schema
1 sheet of A4 dimensions
1 sheet A4 Introduction with Link to Installation software and the Manual
(Registration on the site of Laird is required)

Link to download (without Registration):
getting started
User Manual

Attention - important note:  in the manual, a process "Download Firmware" is described this process must be carried out only with a certain combination of PC hardware / operating system. Please Never start this process, it can lead to total functional failure of the controller, which can be resolved only in the supplying plant. All Controller PR-59 were and are supplied by us with the current firmware, there currently is no need for a renewed download.